
Specially designed kit to fit to 100 Series Toyota Landcruiser with cable driver door locks.
Master and slave actuators
Each kit uses a master actuator for each front door, and a slave actuator for the rear door (4 in total). Master actuators control all actuators
Specific installation
Provides stainless steal rods, superior 3 point fixing clamps with slot / cross head screws and other components to interface with Toyota Landcruiser cable driven central locking
Full complement of hardware
Supplied with all metal brackets, superior 3 point fixing clamps with slot / cross head screws, rods, worms, speed nuts and cabling required for standard installation
Intelligent switch controller
Includes active central locking controller
Additional actuator
A 5th actuator is supplied to lock and unlock the rear doors
Controller Type
Uses REM-090 remote controls
Pre-loomed wire harness
Generous wire loom to connect four doors, all wires fully sheathed
Wiring loom for 5th door limitation
Wire loom does not include extension to tail gate (very rear door)
Wide Operating voltage
Operating voltage +9VDC to +15VDC
Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
Polarity protection
The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
Short circuit protection
The power supply wire to the system is protected against an internal fault within the system
Current rating
All relays rated to carry 15amps continuous, connector 8amps continuous
Installation Guide
Toyota 100 Series Landcruiser and late model Hilux central locking is cable driven. Illustrated installation guide and specifications for the Toyota Cable Central Locking setup.
Manufacturers warranty on Control module
Guarantees product is free from manufacturing defects for 12 months from time of purchase